Vacuum/Scavenging Interface

This is the only scavenging interface system available with a backup, alternative method of scavenging. A newly designed vacuum/scavenging interface with scavenging redundancy.  In the event of vacuum system failure, the anesthetics (not N2O) in the waste gases are filtered by activated charcoal prior to exhausting into the room and the reservoir bag will not over distend. No valves or the problems associated with moving parts. Scavenging flow is easily and precisely controllable between 1 and 10 lpm - visually verifiable at any time.

Scavenging connections (2) designed to accommodate both 19 and 22mm tubes. No more searching for adapters or white tape.

Wall mount, pole mount, post mount, wall outlet mount, and ceiling drop mount configurations are available with any standard suction (vacuum) or EVAC connection, i.e., DISS, Ohio, Chemtron, Schrader or Puritan style quick connects and hose barbs.  

Create Your Vacuum/Scavenging Interface System

 First, select one of the following five mounting options:

000A5631 – Vac/Scav Interface Round Pole Mount Options

Pole Clamps available in sizes:

1” (#25), 1 1/8” (#28), 1 1/4” (#32), 1 1/2” (#36), 1 3/4” (#40), 2” (#47), and 

2 1/4” (#59)

The flowmeter connection for the Round Pole Mount consists of a 45 degree chrome elbow with a 1/4"ID chrome hose barb, which can be connected to an existing hose or an added  hose made to length with a chosen Vacuum Source connector.

000A5632 – Vac/Scav Interface Square Post Mount Options

Set up to fit a 2" wide by a 1 to 1-1/2" deep square post.

Assemblies can be made to accommodate other size square posts. The flowmeter connection for the Square Post Mount consists of a 45 degree chrome elbow with a 1/4"ID chrome hose barb, which can be connected to an existing hose or an added hose made to length with a chosen Vacuum Source connector.

000A5633 – Vac/Scav Interface Ceiling Drop Mount Options           

The flowmeter connection for the Ceiling Drop Mount consists of a 90 degree chrome elbow with the orientation pointing up. This can be connected to an existing hose or an added hose made to length with a chosen Vacuum Source connector.

000A5634 – Vac/Scav Interface Wall Outlet Mount Options

The flowmeter connection for the Wall Outlet Mount will be determined by the outlet gas supply fitting. The unit will have a 2" nipple and a connector attaching straight to the wall plate.

000A5762 – Vac/Scav Interface Wall Mount

The flowmeter connection for the Wall Mount consists of a swivel barb, in order to easily orientate in the needed direction. This can be connected to an existing hose or an added hose made to length with a chosen Vacuum Source connector.